MIT-1
Pro Tips!!!
-Make sure all tires are inflated to door placard suggested.
-Be sure ALL other sensors are out of range of vehicle antenna, (10 ft range min).
-Disable all other WiFi/Bluetooth and electronic accessory devices**.
**Includes HID kits, car audio systems, navigation, back-up cameras, if NOT original equipment, these devices may cause RF disruption.
** Mitsubishi’s requires a special ‘Mitsubishi only’ specific OBD cable.**
‘Mitsubishi only’ OBD cable pictured above for Bartec TPMS tool users.
A properly formatted scan tool is required to learn sensor IDs when replacing sensors.
Using TPMS scan tool
- Inflate all tires
- Read all sensors IDs using tool
- Connect tool to OBDII port
- Reset ECU with tool
- Test drive for up to 10 minutes